Philips Domestic App. HB 578/A free download

File name solarium_©_.pdf

Solarium Service Service Service ! Service Information HB 578/A SUNSTUDIO COMBI ! Service Information Domestic Appliances and Personal Care SAP coding HB 578 GENERAL The full-body tanner Sunstudio Combi HB 578/A is equipped with a 30 minute timer. After the pre-set tanning time, the appliance automatically switches off. The facial tanner (3 x PL 36W) can be switched on/off by means of switch SK 1. It has seven fans - two in the canopy and three in the couch - for adequate cooling of the equipment during operation and 2 fans for body cooling. The voltage supply will only be switched on via the relay (Re) after the timer has been set. The starting current is limited by NTC resistors (NTC 1-9) and phase-correction takes place by means of the capacitors (C 1-9). When choosing a place for the appliance, make sure there is enough free space around the appliance to guarantee proper cooling. TECHNICAL DATA Operating voltage Power consumption Ballast canopy Ballast couch Starter type canopy Starter type couch Lamp type canopy Lamp type couch Timer Safety class Test mark Length of mains cord Irradiation field Dimesions : : : : : : : : : : : : : : : : 230V, 50Hz approx. 3050W 12 x 100W 3 x 40W 12 x 100W 12 x S12 3 x S10 12 x S12 12 x Cleo Performance 100W 3 x PL 36W 12 x Cleo Performance 100W 30 min. double insulation CE approx. 3m approx. 200 x 85 cm approx. 208 x 101 x 91 cm (L x W x H) Published by Philips Domestic Appliances and Personal Care Printed in The Netherlands © Copyright reserved Subject to modification 4322 277 00342 00/05 DISASSEMBLY Canopy Use an appropriate knife to carefully remove the two decorative caps that cover the plastic rivets (7) from the end covers of the lamp housing (35 + 40) and then lever the rivets out of the lamp housing with the knife. Now all the other parts of the lamp housing of the canopy are accessible and can be disassembled. To disassemble the two upper fans (23), first remove the two ballasts and then lift the fans with the fan holders out of the housing so that the fixing screws can be loosened. Mark the position of the filter holders before disassembly to make sure that they can be assembled in exactly the same position when reassembling the lamp housing, which is necessary to ensure that the rivets of the cover of the lamp housing (28) can be reinserted without a problem. To disassemble switches SK 1-3 (52, 54), the housing part (43) must be pushed inwards and downwards and kept apart with a suitable object. The housing part (43) is highly flexible. Appliances from the first series have another rivet in their housing part (43) that must be removed before the housing can be pushed down. This rivet must not be replaced. Use an appropriate screwdriver to carefully remove the 5 screw covers (34) and to loosen the screws (36). 2 1 3 Now the end covers can be removed from the lamp housing. Unscrew the body cooling fan on the left side of the canopy and take it out. Remove the screws. Pull the or